The hd C2
is a passive 1-way miniature speaker, equipped with two 2″ broadband drivers with linear frequency response. The operation can be done via any power amplifier without DSP and makes the hd C2 the optimal solution for decentralized or small sound applications such as restaurants, conference rooms or theaters. The hd C2 can be flexibly and easily installed permanently or can be used mobile. Using the discreet ball joint wall mount, the hd C2 can be simply tilted and tilted or attached to the surface to be fixed extremely close and unobtrusive with the L-angle wall mount. Internal terminal block connections ensure a tool-free and quick connection of the loudspeakers. For optimum adaptation to the room architecture, the loudspeaker can be customized in all RAL colors and special lengths. If wall mounting is not possible, the speakers can be used with the optional 3/8″ threaded base plate and SpeakCON jack on a microphone stand.
Extremely powerful subwoofers of the hd Sub- or hd P-Series with up to 1800 W AES power handling capacity extend the low-frequency sound experience down to the infrasound range. The most elegant solution for extending the bass range of the hd C-Series is the super slim hd Slim265 design subwoofer. Due to its low height of just 102 mm, it fits into any suspended ceiling, can be mounted on a wall or placed invisibly under a piece of furniture.
Applications in existing or newly developed distributed systems can be realized with the optional 100V versions. Modern transformers guarantee high audio performance even over long distances and with small cable cross-sections. Several power taps make it possible to adjust the sound level.
||2x 2″ fullrange chassis
||active at 150 Hz
|Power handling capacity (RMS/Peak)
||50 W / 70 W
||150 Hz – 22 kHz
|Sensitivity (1 W / 1 m)
|Max. sound pressure (1 m)
|Nominal dispersion angle
||horizontal 100° x vertical 50°
||1x clamp connection inside
|Dimensions (W x H x D)
||80 x 205 x 78 mm
||Powder-coated aluminium profile black
Steel grille with acoustic foam
Clamping terminal inside
cable inlet rear, incl. 2x M6 nuts
3/8“-thread + NL4
35 mm flange + NL4